ION L4-2.4L (2007)
8. If the handle will not slide rearward, use pliers in the following steps:
1. Place one end of the pliers on the tab of the hood release lever base, near the bracket.
2. Place the other end of the pliers on the rearward edge of the bracket.
3. Squeeze the pliers.
4. If necessary, place a flat-bladed tool in the slot.
9. Pull the hood cable through the front of the dashboard. Use a flat-bladed tool to loosen the grommet.
Installation Procedure
1. Tape the feeder wire onto the end of the new cable.