ION L4-2.4L (2007)
1. Position the emblem to the fender.
2. Install the emblem fastener by reaching behind the wheel liner.
3. Install the wheel liner fasteners.
Rear Compartment Lid Emblem/Nameplate Replacement
Rear Compartment Lid Emblem/Nameplate Replacement
Tools Required
J 25070 Heat Gun
Removal Procedure
1. When replacing an emblem/nameplate, do the following:
1. Use tape to protect the mounting surface during removal.
2. Use tape for alignment marks for installation of the emblem/nameplate.
2. To remove an emblem/nameplate, heat the emblem/nameplate using a J 25070.
3. Apply the heat using a circular motion for about 30 seconds holding the J 25070 approximately 152 mm (6 in) from the surface.
Notice: Refer to exterior trim emblem removal notice in Service Precautions.
4. Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.
5. When replacing, remove all adhesive as follows:
*
For body panels, use a 3M(TM) Scotch Brite molding adhesive remover disk 3M(TM) P/N 07501 or equivalent.
*
For plastic panels, use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture, by volume of isopropyl alcohol
and water to remove the adhesive.
