ION L4-2.4L (2007)
Tighten the bolts to 45 N.m (33 lb ft).
6. Install the lower lock pillar trim.
7. Install the upper lock pillar trim.
8. Install the rear seat back.
9. Install the rear seat cushion.
10. If equipped, enable the roof rail airbag module. Refer to SIR Disabling and Enabling.
Windshield Garnish Molding Replacement
Windshield Garnish Molding Replacement
Removal Procedure
Caution: Use care when working around the roof rail inflator module because sharp objects may puncture the roof rail airbag and the
airbag will not deploy correctly.
In order to avoid personal injury, if any part of the module is damaged replace the entire module
1. Using a small, flat-bladed tool, remove the fastener trim cover.
2. Remove the screw from the windshield garnish molding.
3. Disengage the retaining clips by pulling on the garnish molding.
4. Lift the bottom of the molding out from between the windshield pillar and the instrument panel. Remove the molding from the vehicle.
Installation Procedure
1. Position the windshield garnish molding in the vehicle. Install the molding by pushing the molding over the clip locations.