ION L4-2.4L (2007)
1. Place the trim cover over the pad. Install the cover by pressing on the hook and loop locations.
2. Install the pad and the trim cover on the seat.
3. Connect the J hook retainers. Ensure that the rear J clip material flap is over the fold-flat cable.
4. If the seat is equipped with lumbar support, perform the following procedure:
1. Pull the lumbar cable sleeve forward.
2. Using a sharp-bladed tool, make a small slit where the lumbar actuator comes in contact with the cover.
3. Install the lumbar knob by pushing firmly.
4. Adjust the lumbar knob to ensure that the lumbar is operating correctly.
5. Install the front seat to the vehicle.
Caution: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim.
Failure to do so may cause the system to malfunction.
6. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is
removed. Refer to Passenger Presence System Programming and Setup.
Seat Cushion Cover and Pad Replacement - Front (Non-Fold Flat)
Seat Cushion Cover and Pad Replacement - Front (Non-Fold Flat)
Removal Procedure