ION L4-2.4L (2007)
1. Install the seat cushion trim cover on the pad.
2. Apply pressure over the hook and loop retainers to secure the retainers.
3. Install the trim and pad on the seat cushion frame.
4. Push the seat cushion trim cover between the cushion and the seat back and the adjusters.
5. Connect the J-hook retainers.
6. If the seat is equipped with lumbar support, perform the following procedure:
1. Pull the lumbar cable sleeve forward.
2. Using a sharp-bladed tool, make a small slit where the lumbar actuator comes in contact with the cover.
3. Install the lumbar knob by pushing firmly.
4. Adjust the lumbar knob to ensure that the lumbar is operating correctly.
7. Install the seat side trim cover.
8. Install the front seat.
Caution: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim.
Failure to do so may cause the system to malfunction.
9. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is
removed. Refer to Passenger Presence System Programming and Setup.
Seat Cushion Inner Trim Panel Replacement
Seat Cushion Inner Trim Panel Replacement
Removal Procedure