ION L4-2.4L (2007)
10. Loosen the 2 insulator nuts (1) on the brake pressure modulator valve assembly.
11. Remove the brake modulator assembly from modulator bracket by pulling straight up.
Installation Procedure
Important: When installing a new brake modulator assembly, do NOT remove the shipping plugs from the pipe ports until after installation
into the vehicle.
1. Install the brake modulator assembly to the modulator bracket.
Notice: Refer to Fastener Notice.
2. Tighten the 2 brake pressure modulator assembly insulator nuts (1).
Tighten the nuts to 8 N.m (71 lb in).