ION L4-2.4L (2007)
Brake Hose/Line: Service and Repair
Rear Brake Hose Replacement (Caliper)
Rear Brake Hose Replacement (Caliper)
Caution: Refer to Brake Fluid Irritant Caution.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice.
Removal Procedure
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Clean all dirt and foreign material from the brake hose ends and brake pipe fitting.
4. Using a backup wrench on the hose fitting (2), disconnect the brake pipe fitting (1) from the brake hose. Cap or plug the brake pipe fitting end and
the brake hose end to prevent fluid loss and contamination.
5. Remove the brake hose retaining clip (3) from the hose mounting bracket.
6. Remove the hose from the mounting bracket.
7. Remove the brake hose-to-caliper bolt (1) from the brake caliper.
8. Remove the brake hose (3) from the brake caliper.
9. Remove and discard the 2 copper brake hose gaskets (2). These gaskets may be stuck to the brake caliper and/or the brake hose end.
10. Cap or plug the opening in the brake caliper and the brake hose (3) to prevent fluid loss and contamination.
Installation Procedure
