ION L4-2.4L (2007)
Notice: Refer to Fastener Notice.
Important: Tighten the park brake lever assembly mounting nuts in the sequence shown.
2. Install the park brake lever assembly mounting nuts.
Tighten the nuts in sequence to 25 N.m (18 lb ft).
3. Secure the rear cable fittings (2) to the park brake lever bracket (1). Attempt to pull the park brake cables free of the lever bracket, to ensure that
the retaining tabs on the fittings are properly secured.
4. Install the cable ends (3) to the cable equalizer.
5. Connect the electrical connector (1) to the park brake warning lamp switch.
6. Adjust the park brake cable tension.
7. Install the front floor console.
8. Enable the SIR system.