ION L4-2.4L (2007)
Important: Spraying the heater core seal and the dashmat with a soap and water mixture will ease installation.
2. Install the heater core cover from the right side. Slide up and forward into position. Align the drain tube with the hole in the front of dash. Raise
the heater core cover into position while aligning holes with the locating pins from the HVAC module.
Notice: Refer to Fastener Notice.
Important: Make certain that the heater core cover is properly positioned and is fully seated on the HVAC module before installing the
screws. Be sure to install all heater core cover screws.
3. Install the heater core cover screws.
Tighten the heater core cover screws to 1.8 N.m (15 lb in).
