ION L4-2.4L (2007)
6. Release the blower motor retaining tab and remove the motor from the cup.
Installation Procedure
1. Install the blower motor (1) into the motor cup (2) that was cut out of the lower case.
Notice: Refer to Fastener Notice.
2. Install the blower motor nuts (3).
Tighten the nuts to 2.4 N.m (21 lb in).
3. Attach the service ring (4) to the motor cup (2) with the screws (5) included in the kit.
Tighten the screws to 1.8 N.m (15 lb in).
4. Install the blower motor and service ring into the HVAC module using the screws (5) included in the kit. Make certain the blower motor electrical
connector is pointing rearward in the vehicle.
Tighten the screws to 1.8 N.m (15 lb in).
5. Install the lower blower motor cover.
6. Install the lower blower motor cover retaining screws.