ION L4-2.4L (2007)
Important: Verify that the heater core cover is properly positioned and is fully seated on the HVAC module before installing the screws.
Install all of the heater core cover screws.
7. Install the heater core cover and the screws.
Tighten the screws to 1.8 N.m (15 lb in).
8. Replace the drain tube seal.
9. Replace the front of dash seal.
10. Inspect and replace the following HVAC module seals if damaged:
*
The defrost duct seal
*
The HVAC module to cross car duct seal
*
The center air outlet duct seal
*
The center floor air outlet duct seal
*
The air inlet seal
