ION L4-2.4L (2007)
3. Release the retainer from the underhood electrical center and position the electrical center (2) to the electrical center bracket.
Important: Ensure that the wiring harnesses are not pinched when securing the electrical center to the bracket.
4. Secure the underhood electrical center locking tabs (1) to the electrical center bracket.
5. Position the electrical center bracket onto the studs at the surge tank and on the frame rail.
6. Install the underhood electrical center bracket mounting bolt. Do not tighten yet.
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the underhood electrical center bracket mounting nut.
Tighten the nut to 10 N.m (89 lb in).
8. Install the cooling system surge tank mounting nut.
Tighten the nut to 10 N.m (89 lb in).
9. Tighten the underhood electrical center bracket mounting bolt.
Tighten the bolt to 25 N.m (18 lb ft).
10. Secure the forward lamp harness retainer to the outboard side of the ECM tray.
11. Secure the EPS cable retainer to the underhood electrical center bracket.
