ION L4-2.4L (2007)
1. Install the wheel bearing/hub assembly to the brake backing plate and the rear axle assembly.
Notice: Refer to Fastener Notice.
2. Install the wheel bearing/hub assembly mounting nuts (3) to the axle assembly. Tighten the nuts evenly, in a cross-pattern.
Tighten the nuts to 45 N.m (33 lb ft) plus 30 degrees.
3. Connect the electrical connector (2) to the wheel speed sensor, if equipped with ABS.
4. Remove the support (1) from the brake backing plate.
5. Install the plug to the drum brake actuator access hole in the backing plate.
6. Install the brake drum.
7. Install the tire and wheel assembly.
8. Lower the vehicle.
