ION L4-2.4L (2007)
Wheels: Description and Operation
Replacement Wheels Description
Replacement Wheels Description
Replace the wheel if any of the following conditions exist:
*
The wheel exhibits excessive runout
*
The wheel is bent
*
The wheel is cracked
*
The wheel is severely rusted
*
The wheel is severely corroded
Important: Air leaks caused by porosity on aluminum wheels are repairable.
*
The wheel leaks air
Caution: If you are replacing the wheel(s), the wheel stud(s), the wheel nut(s) or the wheel bolt(s), install only new Saturn original equipment
parts. Installation of used parts or non-Saturn original equipment parts may cause the wheel to loosen, loss of tire air pressure, poor vehicle
handling and loss of vehicle control resulting in personal injury.
Notice: The use of non-Saturn original equipment wheels may cause:
*
Damage to the wheel bearing, the wheel fasteners and the wheel
*
Tire damage caused by the modified clearance to the adjacent vehicle components
*
Adverse vehicle steering stability caused by the modified scrub radius
*
Damage to the vehicle caused by the modified ground clearance
*
Speedometer and odometer inaccuracy
Replace the wheel, the wheel studs and the wheel/nuts, or the wheel bolts if applicable, if any of the following conditions exist:
*
The wheel has elongated bolt holes.
*
The wheel/nuts, or bolts if applicable, loosen repeatedly.
Steel wheel identification is stamped into the wheel near the valve stem.
Aluminum wheel identification is cast into the inboard side of the wheel.