ION L4-2.4L (2007)
7. Release the pipe retainers (1) from the vehicle underbody.
8. Remove the EVAP purge line from the pipe retainers.
9. Lower the rear of the line while moving the line rearward slightly, then lower the front of the line.
10. Remove the EVAP purge line from the vehicle.
Installation Procedure
1. Position the EVAP purge line to the vehicle.
2. With the rear of the line positioned slightly rearward and down, raise the front of the line into position.
3. Install the remainder of the line into position.
4. Install the EVAP purge line to the pipe retainers.
5. Secure the pipe retainers (1) to the vehicle underbody.
Notice: Refer to Fastener Notice.
6. Install the rear brake hose brackets to the body studs and install the rear brake hose bracket nuts.
Tighten the nuts to 10 N.m (89 lb in).
7. Install the EVAP canister.
8. Lower the vehicle.
