ION L4-2.4L (2007)
6. Remove the rear tether snap-in fastener.
7. Remove the inflator fastener.
8. Rotate the inflator inboard to disengage the inflator bracket tabs from the sheet metal.
9. Remove the roof rail module from the vehicle.
10. Fully deploy the module before disposal. Refer to Inflator Module Handling and Scrapping.
Installation Procedure
1. Install the inflator bracket tabs in the slots in the upper lock pillar sheet metal.
Notice: Refer to Fastener Notice.
2. Install the inflator fastener.
Tighten the fasteners to 10 N.m (89 lb in).
Important: Pull up on each snap-in fastener without depressing the locking tab to verify that the fastener is installed correctly.
3. Install the rear tether snap-in fastener. Ensure that the fastener locks in place.
