ION L4-2.4L (2007)
1. Turn OFF the ignition.
2. Remove the ignition key.
3. Put on safety glasses.
4. Remove the inflator module.
*
If you are removing the steering wheel module, refer to Inflatable Restraint Steering Wheel Module Replacement.
*
If you are removing the I/P module, refer to Inflatable Restraint Instrument Panel Module Replacement.
*
If you are removing a roof rail module, refer to Inflatable Restraint Roof Rail Module Replacement - Front.
Caution: Refer to SIR Inflator Module Handling and Storage Caution.
5. Place the inflator module on a work bench, with the vinyl trim cover facing up and away from the surface.
6. Clear a space on the ground about 1.85 m (6 ft) in diameter for deployment of the inflator module or deployment fixture. If possible, use a paved,
outdoor location free of activity. Otherwise, use a space free of activity on the shop floor. Ensure you have sufficient ventilation.
7. Clear the area of loose or flammable objects.
Important: Dual stage deployments are only used in steering wheel and I/P inflator modules. If stage 1 was used to deploy a dual stage
inflator module, stage 2 may still be active. If disposal of a dual stage module is required, both deployment loops must be energized to
deploy the air bag.
8. If you are deploying a steering wheel inflator module, place the inflator module in the center of the space.
9. When deploying an I/P inflator module, perform the following instructions:
1. Place the SA9413NE SIR Deployment Fixture (2) in the center of the cleared area.
2. Fill the deployment fixture with water or sand.
3. Using the proper nuts and bolts, mount the I/P module (1) to the deployment fixture (2), with the vinyl trim facing up.
4. Securely tighten all fasteners that hold the I/P module (1) to the deployment fixture (2).
