ION L4-2.4L (2007)
Impact Sensor: Service and Repair
Inflatable Restraint Side Impact Sensor Replacement (Sedan)
Inflatable Restraint Side Impact Sensor Replacement (Sedan)
Removal Procedure
Caution: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR
Disabling and Enabling. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or
unnecessary SIR system repairs.
Caution: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is
securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR
system repairs.
1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Move the seat to the full forward position.
3. Remove the lower trim panel from the center pillar.
4. Remove the connector position assurance (CPA) from the harness connector on the inflatable restraint side impact sensor (SIS).
5. Disconnect the harness connector from the SIS.
6. Loosen the SIS mounting fasteners.
7. Remove the SIS from the center pillar by sliding the SIS up and out of the keyholes in the sheet metal.
Installation Procedure
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Install the SIS to the center pillar by sliding the sensor fasteners into the keyhole in the sheet metal.
