ION L4-2.4L (2007)
Installation Procedure
1. Install the wheel bearing/hub assembly and spacer (1) to the steering knuckle and wheel drive shaft. Position the spacer as noted prior to removal.
Notice: This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a standard
tap. If a standard tap is used, damage to the joint threads will occur.
Notice: Refer to Fastener Notice.
2. Install the wheel bearing/hub assembly mounting bolts. Tighten the bolts evenly to draw the bearing assembly to the steering knuckle, then tighten
the bolts to specifications.
Tighten the bolts to 115 N.m (85 lb ft).
3. Install the wheel speed sensor jumper connector to the harness retaining bracket on the strut, if equipped with ABS.
4. Connect the electrical connector to the wheel speed sensor jumper, if equipped with ABS.
5. Install the brake rotor, and install the brake caliper and bracket as an assembly.
6. Install the wheel drive shaft nut.
7. Install the tire and wheel assembly.
8. Lower the vehicle.
