ION L4-2.4L (2007)
2. Tighten the rear transaxle mount to frame bolts.
Tighten the bolts to 60 N.m (44 lb ft).
Important: Rotate the rear transaxle mount heat shield clockwise until the tab is seated on the mount bracket.
3. Hand start the rear transaxle mount through bolt.
Important: The front and rear transmission mounts must be allowed to settle with the through bolts loosened.
4. Loosen the front transaxle mount through bolt.
5. Tighten the transaxle mount through bolts in the following order:
1. Tighten the rear bolt to 100 N.m (74 lb ft).
2. Tighten the front bolt to 100 N.m (74 lb ft).
6. Lower the vehicle.
Transmission Mount Replacement - Left Side
Transmission Mount Replacement - Left Side
Removal Procedure
1. Remove the underhood electrical center bracket from the vehicle and reposition the electrical center.
2. Support the transmission with a floor jack. Use a piece of wood between the jack and the transmission.
3. Remove the transmission mount-to-transmission bracket bolts.