L200 L4-2.2L VIN F (2002)
1.
Position new tuned power steering pressure hose, P/N 22714174, into vehicle. Route the power steering pressure hose in the vehicle as noted
during removal procedure.
2.
Hand start but do NOT tighten power steering pressure hose to steering gear connection.
3.
Hand start but do NOT tighten power steering pressure hose to pump connection.
4.
Hold fitting at the gear end of the pressure hose so that it does not contact (ground out) against any other part of the vehicle.
5.
Tighten power steering pressure hose to gear connection.
Tighten
Tighten the power steering pressure hose to steering gear 27 N.m (20 ft-lbs).
6.
Twist the power steering pressure hose at the pump end so that the hose is centered between the brake master cylinder and the heater hoses.
7.
While holding power steering pressure hose in centered position, tighten power steering pressure hose to pump.
Tighten
Tighten the power steering pressure hose to pump: 27 N.m (20 ft-lbs).
8.
Attach clip between power steering pressure hose and power steering return hose.
9.
Inspect power steering pressure hose routing to make sure that there are no ground outs anywhere along the power steering pressure hose and
readjust, if necessary.
