L200 L4-2.2L VIN F (2002)
Body Emblem: Technical Service Bulletins
Body - Placement of Model Badges
Placement of Vehicle Model Badges on Decklid Applique or Liftgate #01-T-36A - (Apr 24, 2003)
Placement of Vehicle Model Badges on Decklid Applique or Liftgate
2002 - 2003 Saturn L-Series vehicles
Due to the addition of 2003 model year vehicle badge placement procedures, this bulletin has been revised and supersedes bulletin 01-T-36, which
should be discarded.
Purpose
The purpose of this bulletin is to provide installation procedures necessary for correct placement of model badges on rear decklid or liftgates.
Installation Procedure
The following steps are common to both sedan and wagon models and must be performed before beginning emblem installation.
The model designation emblems ie. L100, LW200 etc. will be placed on the left hand side of the decklid applique or liftgate. The V6 emblem, on those
models equipped, will be placed on the right side of the decklid applique or liftgate.
1. Wash the applique or liftgate with mild soap and water solution and dry thoroughly.
2. Wash the areas where the emblems are to be bonded using a 50/50 mixture of isopropyl alcohol; (rubbing alcohol) and water, and dry thoroughly.
Proceed to appropriate emblem procedure to complete installation.
Important
Do not use solvent type cleaning agents on decklid appliques. Exposure to these solvents may cause damage to the applique.
Emblem Placement Sedan Models 2002 Model Year
1. Cut a piece of 25 mm (1 in.) masking tape approximately 254 mm (10 in.) long.
Important
Do not substitute 25 mm (1 in.) masking tape with other dimensions. This will cause a misplacement of the emblem. Tape with 25 mm (1 in.)
dimension is available locally at home building centers or paint supply stores.
2. Place the masking tape so the bottom edge of the tape is aligned with the horizontal feature line molded in the applique approximately 3 mm above
the chrome strip.
Important
Due to the difference in size between the L100 emblem and the L200 and L300 emblems, follow the appropriate steps below.
L100 Emblem Placement Sedan Models 2002 Model Year
1. Using a measuring tape, measure along the top edge of masking tape from the left hand edge of the applique and make a vertical reference line at a
