L200 L4-2.2L VIN F (2002)
during the installation process.
5. Carefully align the emblem so the left edge of the "L" is aligned with your vertical reference mark and the top of the emblem is aligned with the
bottom edge of the masking tape.
6. Using your hand, apply medium hand pressure to each individual character for a minimum of three seconds. This will ensure the emblem bonds
properly to the liftgate.
7. Remove the clear protective tape from the front of the emblem.
V6 Emblem Placement on Wagon Models 2002-2003 Model Year
1. Cut a piece of 76 mm (3 in.) masking tape approximately 279 (11 in.) inches long.
2. Align the top edge of the tape with the bottom edge of the liftgate upper feature line.
3. Using a measuring tape, measure along the bottom edge of the masking tape from the right edge of the liftgate and make a vertical reference mark
at a distance of 146 mm (5 3/4 in.).
4. Remove white protective tape from backside of the emblem, being careful not to loosen the clear adhesive tape on the front of the emblem.
Important
Do not remove the clear protective tape from the front of the emblem. This tape is used to maintain the alignment of the individual characters
during the installation process.
5. Carefully align the right hand edge of the "6" on the emblem with the vertical reference mark and the top edge of the emblem with the bottom edge
of the masking tape.
6. Using your hand, apply medium hand pressure to each individual character for a minimum of three seconds. This will ensure the emblem bonds
properly to the liftgate.
7. Remove the clear protective tape from the front of the emblem.
L200 and L300 Emblem Placement 2003 Model Year
1. Install a 254 mm (10 in.) piece of (3/4 in.) masking tape. Align the upper edge of the masking tape with the lower edge of the deck lid applique
chrome strip.
2. Install a second 254 mm (10 in.) piece of (3/4 in.) masking tape. Align the upper edge with the lower edge of the previously installed piece.
