L200 L4-2.2L VIN F (2002)
A. Use an air release tool, 3M(R) P/N 71604, or equivalent, or straight pin to puncture the bubble at its edge.
B. Use finger or squeegee to force air out through the hole made in the film.
Pinstripe Care
-
DO wash the pinstripe with an approved car wash detergent, Saturn P/N 21112715 (in Canada, GM P/N 993279), or equivalent, and rinse
thoroughly.
-
DO keep high pressure car wash nozzles at least 0.46 m (1.5 ft) from the edge of the pinstripes/vinyl graphics. High pressure spray may cause the
edge of the pinstripes/vinyl graphics to peel.
-
DO test any cleaning solution on a small section of the pinstripes/vinyl graphics before using the solution.
-
DON T use any aromatic solvents such as acetone, M.E.K., toluene, paint thinner, lacquer thinner on the pinstripes/vinyl graphics. Any solvent
may soften or smear colors.
-
DON T overcoat the pinstripes/vinyl graphics with clear paint.
-
DON T apply wax over pinstripes/vinyl graphics, especially if the wax contains any petroleum distillates such as silicone. Wax that has dried along
the edges of pinstripes and graphics can be removed by softening it with isopropyl (rubbing) alcohol and cotton swabs. Be sure to rinse the area
after cleaning.
