L200 L4-2.2L VIN F (2002)
2.9
Loosen rear brake pipe (rear port) at master cylinder.
2.10
Allow brake fluid to flow from rear master cylinder port.
2.11
Tighten rear brake pipe into master cylinder.
2.12
Loosen rear brake pipe at master cylinder 1/4 turn.
2.13
Depress brake pedal slowly until fluid is seen coming from pipe fitting.
2.14
Tighten rear brake pipe into master cylinder while pedal is being depressed.
2.15
Slowly release pedal.
2.16
Repeat sequence until all air is removed from rear (primary) master cylinder bore and torque brake pipe-to-master cylinder nuts.
Torque:
Brake Pipe-to-Master Cylinder Nuts: 16 Nm (12 ft. lbs.)
3. Bleed individual calipers and wheel cylinders.
IMPORTANT: To assist in freeing trapped air, tap lightly on caliper casting with a rubber mallet.
3.1
Place wrench over bleeder screw.
3.2
Attach transparent hose over bleeder screw nipple. Submerge other end of hose in a transparent container of brake fluid.
3.3
Loosen bleeder screw.
3.4
Apply brake pedal slowly and hold.
3.5
Tighten bleeder screw.
3.6
Release brake pedal.
3.7
Repeat sequence until all air is removed from brake pipes and torque bleeder screw.
Torque:
Front Caliper Bleeder Valves: 8 Nm (71 inch lbs.)
