L200 L4-2.2L VIN F (2002)
4. Slide camshaft sprocket(s) and timing chain on guide pins toward camshaft(s). Rotate camshaft(s) with 24 mm open-end wrench to properly align
camshaft(s) and sprocket(s).
5. Install new camshaft sprocket bolt and tighten. This will pull the camshaft sprockets into cams. Hold camshaft with 24 mm open end wrench
during torquing.
Torque:
Camshaft Sprocket Bolts: 85 Nm (63 ft. lbs.) + 30 degrees
6. Remove Camshaft Sprocket Holding Tool (J43655).
7. Install front camshaft cap(s).
Torque:
Camshaft Bearing Cap Bolts: 10 Nm (89 inch lbs.)
NOTICE: Apply Loctite 2420 to upper timing chain guide bolts.
8. Install upper timing chain guide.
Torque:
Timing Chain Guide (Upper) Bolts: 10 Nm (89 inch lbs.)
9. Install rear intake camshaft bearing cap.
Torque:
Intake Camshaft Rear Bearing Cap Bolts: 25 Nm (18 ft. lbs.)
10. Install power steering pump.
Torque:
Power Steering Pump Bolts: 25 Nm (18 ft. lbs.)
11. Install ignition coil, PCV fresh air hose, ground strap. fuel line, harness bracket, and cam cover assembly.
12. Connect negative battery cable.
Torque:
Battery Terminal Bolts: 17 Nm (13 ft. lbs.)
