L200 L4-2.2L VIN F (2002)
3. Remove valve lash adjusters.
INSTALLATION
1. Install valve lash adjusters.
2. Install rocker arms.
3. Install camshafts.
NOTICE: After cylinder block, head or lifter replacement, it will be necessary to allow the engine to idle for three to five minutes. If lifters are noisy,
warm the engine up at a low rpm (less than 2000). After the coolant temperature has reached approximately 85 degrees C (185 degrees F), cycle the
engine rpm from idle to 3000 for approximately 10 minutes or drive the vehicle eight kilometers (five miles) to purge the air. If the air cannot be
purged, the faulty lifter(s) will have to be replaced.
Lifters that are pumped up may cause PCM misfire codes to set. Continue to operate the engine until the lifters bleed down. Using the scan tool, clear
codes and malfunction history.