L200 L4-2.2L VIN F (2002)
3. Use flat blade screwdriver to lift faceplate tabs over barbs and rotate face plate off of control head.
INSTALLATION
1. Press face plate onto control head until retaining barbs are seated.
2. Install temperature and mode knobs by aligning knob with shaft pattern. Knobs should fit flush with face plate. If not, remove and rotate 180
degrees.
IMPORTANT: Buttons are interchangeable. Proper order from left to right: A/C, rear defog, recirculation.
3. Install A/C, rear defog, and recirculation buttons.
Blower Motor Switch
REMOVAL
