L200 L4-2.2L VIN F (2002)
21.
Insert nozzle tip of spray gun so spray pattern will be parallel to the evaporator face.
22.
Apply cooling coil coating using short bursts and rotating the nozzle tip up and down. This will allow for an even distribution and to ensure full
coverage of the evaporator.
23.
Apply provided sealant in kit to service door at tongue and groove location as shown.
Note:
Proper sealing is important to prevent condensation from leaking into passenger compartment.
24.
Install evaporator core service door (P/N 22679783) to module and install screws.
Tighten
