L200 L4-2.2L VIN F (2002)
4.
Hand crimp sleeve using the approved crimping tool. Gently tug on wires to make sure they are secure before applying heat to them.
6.
Apply heat using Ultratorch (or equivalent), heating splice sleeve to 175° C (347° F). Heat until glue flows around edges of splice sleeve.
Caution:
Do not use a match or open flame to apply heat to splice sleeve.
Delayed Blower Kit Installation and Testing Procedure (for C60 manual HVAC systems only)
Important:
This procedure is for vehicles equipped with manual HVAC systems (RPO C60) only. If vehicle is equipped with automatic climate control
(RPO C68), go to "Delayed Blower Motor Control Activation" section in this bulletin.
Before starting the following procedure, obtain the following parts:
^
3 Wire Splice Connector, P/N 22709318
^
Delayed Blower Control Module Kit, P/N 22679784
^
Relay Kit, P/N 22688666
^
Splice Sleeves - Salmon, P/N 12089189 (need 5 sleeves)
^
Splice Sleeves - Yellow, P/N 12089191 (need 5 sleeves) Splice Sleeves - Blue, P/N 12089190
Installing the Delayed Blower Motor Control Module
