L200 L4-2.2L VIN F (2002)
VEHICLE RUNNING, HIGH BLOWER SETTING DOES NOT OPERATE BLOWER DOES NOT OPERATE AFTER SPECIFIED DELAY TIME
(MAKE SURE THAT ALL WIRES TO MODULE ARE PROPERLY CONNECTED. USE A VOLTMETER TO CHECK THAT THE PROPER
SIGNAL IS APPLIED TO EACH WIRE.)
Delayed Blower Motor Control Activation Procedure (for C68 automatic climate control Systems only)
Important:
This procedure is for vehicles equipped with automatic climate control systems (RPO C68) only. If vehicle is equipped with a manual HVAC
system (RPO C60), go to "Delayed Blower Kit Installation" section in this bulletin.
Before starting the following procedure, obtain the following parts:
^
3 Wire Splice Connector, P/N 22709318
^
Splice Sleeves - Yellow, P/N 12089191 (need 3 sleeves)
1.
Disable SIR system. Refer to "SIR Disable/Enable" procedure in the appropriate model year Saturn L-Series Restraints Service Manual.
Caution:
When performing service on or around SIR components or SIR wiring, follow the cautions and procedures in the SIR Service Manual to
temporarily disable the SIR System. Failure to follow the disable procedures could result in possible airbag deployment, personal injury or
otherwise unneeded SIR System repairs.
2.
Record radio presets stations and disconnect negative battery cable.
3.
Remove lower left garnish molding covering the Lower Instrument Panel Fuse Block (LIPFB).
