L200 L4-2.2L VIN F (2002)
8. Install heater pipes into case and then into heater core. Shorter pipe is upper.
9. Install heater pipe retaining clamps.
IMPORTANT: Lower heater pipe clamp hinge fits into the tab of the heater core retainer strap.
10. Install heater core retaining strap.
11. Install TXV/Heater pipe seal.
12. Install TXV.
Torque:
TXV-to-Block Bolts: 7.0 N.m (62 in-lbs)
13. Install recirculation doors.
14. Install recirculation door rod to small door. With both doors held firmly closed, snap rod into retainer clip and close clip.
