L200 L4-2.2L VIN F (2002)
Torque:
Fuel Rail Attaching Bolts: 10 N.m (89 in-lbs)
3. Connect fuel injector electrical connectors. Push in until a click is heard and pull back to insure engagement.
4. Connect PCV valve hose and connect vacuum line to fuel pressure regulator. Make sure they are fully seated.
CAUTION: LUBRICATE WITH CLEAN ENGINE OIL THE MALE END OF THE FUEL RAIL THAT CONNECTS WITH THE FUEL
SUPPLY LINE. FIRMLY PRESS ON FEMALE COUPLER UNTIL A CLICK IS HEARD, THEN PULL BACK TO CONFIRM
ENGAGEMENT. PINCHED, KINKED OR DAMAGED FUEL LINES MUST BE REPLACED.
5. Lubricate with clean engine oil the male fuel feed line and male fuel return line connections. Attach the fuel feed line and pull back to confirm
engagement. Attach the fuel return line and pull back to confirm engagement.
6. Connect negative battery terminal.
Torque:
Battery Terminal Bolts: 17 N.m (13 ft-lbs)
7. Prime fuel system.
7.1 Cycle ignition On for 5 seconds and then Off for 10 seconds.
7.2 Repeat step 7.1 twice.
7.3 Crank engine until it starts (maximum starter motor cranking time is 20 seconds).
7.4 If engine does not start, repeat steps 7.1-7.3.
8. With engine Off and ignition On, pressurize the fuel system and check for leaks.
9. Install air tube and air filter cover.
