L200 L4-2.2L VIN F (2002)
2. Remove headliner and garnish moldings from vehicle.
IMPORTANT: Spaceframe clips and plastic guides must be removed from structure. Spaceframe clips are designed for one use only. The new
inflator assembly will contain new spaceframe clips and plastic guides attached to the assembly.
3. Remove fasteners from inflator retention tabs and spaceframe clips-to-structure in locations shown in illustration.
INSTALLATION
CAUTION: IP ORIGINAL BAG IS BEING INSTALLED CARE MUST BE TAKEN TO OBSERVE THE FOLLOWING POINTS:
^
ROOF RAIL MUST BE UNDAMAGED AND STRAIGHT.
^
SCREW HOLE IN CURTAIN INFLATOR FABRIC MUST NOT BE FRAYED.
^
WASHER ON RETAINING SCREWS MUST FIRMLY CLAMP THE BAG FLAT WHEN TORQUED.
NOTE:
^
If curtain inflator is being replaced due to deployment, the spaceframe snap clips must be replaced. The new curtain inflator assembly is shipped
with plastic guides and new spaceframe clips that are pre-torqued.
^
Care must be taken when removing spaceframe clips as not to damage roof rail sheet metal.