L200 L4-2.2L VIN F (2002)
4.
Remove left rear seat shoulder belt cover to expose shoulder belt fastener.
5.
Remove left shoulder belt fastener and left shoulder belt.
6.
Fold down rear seat back.
7.
Route left shoulder belt out of C-pillar trim access slot.
8.
Remove left C-pillar trim by pulling gently at C-pillar clip locations.
9.
Repeat Steps 4 - 8 for right side.
10.
Remove Connector Position Assurance (CPA) retainer.
11.
Disconnect left and right curtain inflator module (YEL 2-way) connectors.
Caution:
SIR SYSTEM SHOULD BE DISABLED BEFORE REMOVAL OF THE INFLATOR. DO NOT TWIST THE INFLATOR.
12.
Remove only the fasteners from inflator module to spaceframe and remove module.
Important:
The foam tape must be securely fastened between the backlite flange of the body and the airbag canister when the airbag is fully installed.
