L200 L4-2.2L VIN F (2002)
2. It vehicle is equipped with cruise control, push switches out from rear of steering wheel.
ASSEMBLY
1. If vehicle is equipped with cruise control, install switches by pushing them in place from the front of the wheel.
2. Install screws in steering wheel shroud.
INSTALLATION
1. Remove yellow tab or tape from SIR Coil assembly.
2. Route wiring through steering wheel and install steering wheel onto steering shaft noting orientation notch that locates steering wheel in correct
position.
IMPORTANT: A new steering wheel attachment nut must be used.
3. Install new steering wheel attachment nut.
^
Steering Wheel Nut: 40 Nm (30 ft. lbs.)
4. Connect cruise control (if equipped) switch connectors and attach harness to wheel.
5. Connect inflator module wiring harness and install harness integral connector lock device.
6. Install inflator module into steering wheel. Be sure to seat all four attachment points.
7. Enable the SIR system.