L200 L4-2.2L VIN F (2002)
1. Thread outer tie rod onto inner tie rod.
IMPORTANT: The tie rod ends must be thoroughly cleaned before installing and tightening.
2. Install tie rod end into steering knuckle.
3. Using Linkage Installer J44015 (or equivalent), seat the tie rod end into the knuckle and tighten.
^
Tie Rod End Linkage Installer: 45 Nm (33 ft. lbs.)
NOTICE: Use a new nut. Torque retention of old nut may not be sufficient.
NOTICE: Hold ball stud from turning when installing nut. The boot can become torn and damaged if the ball stud turns.
4. Check boot for damage and replace part if damaged.
5. Remove linkage installer and install new tie rod end nut and tighten.
^
Tie Rod End-to-Steering Knuckle Nut: 60 Nm (44 ft. lbs.)
6. Hand tighten inner tie rod-to-outer tie rod jam nut.
