L200 L4-2.2L VIN F (2002)
NOTICE: Hold ball stud from turning when removing nut. The boot can become torn and damaged if the ball stud turns.
3. Install stabilizer bar link to strut assembly.
^
Stabilizer Bar Link-to-Strut: 65 Nm (48 ft. lbs.)
4. Inspect boots for damage and replace if damaged.
5. Reattach brake hose, and ABS wiring to strut, if vehicle is equipped.
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors. Failure to do so can cause wheel bolts
to loosen in service.
6. Position wheel onto hub.
7. Install wheel bolts and tighten in a crisscross pattern.
7.1.
Hand tighten all five wheel bolts.
7.2.
Use a torque wrench to tighten wheel bolts using a crisscross pattern.
^
Wheel Bolts (Initial Torque): 63 Nm (46 ft. lbs.)
7.3.
Use a torque wrench to final tighten wheel bolts using a crisscross pattern.
^
Wheel Bolts (Final Torque): 125 Nm (92 ft. lbs.)
8. Lower vehicle from hoist.
9. Perform vehicle wheel alignment.
