L200 L4-2.2L VIN F (2002)
Band Apply Servo: Service and Repair
Low/Reverse Servo Assembly Replacement
LOW/REVERSE SERVO ASSEMBLY REPLACEMENT
REMOVAL
CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON THE HOIST. TO HELP
AVOID PERSONAL INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE
OPPOSITE END FROM WHICH COMPONENTS ARE BEING REMOVED.
1. Position vehicle on a hoist and raise vehicle.
2. Remove transaxle oil pan.
3. Remove oil feed pipe-to-low/reverse servo assembly bolt.
NOTICE: Remove servo cover bolts evenly to prevent damage to servo cover.
4. Remove low and reverse band servo cover assembly bolts.
5. Pull oil feed pipe away from servo cover and remove servo assembly.
DISASSEMBLY
1. Remove piston pin assembly from servo cover.
2. Remove snap ring from servo pin.
3. Remove piston and servo cushion springs from servo pin.
4. Remove servo piston seals from cover.
5. Discard servo piston seals.
6. Inspect all components for damage.
7. Inspect fluid feed holes for the proper opening.
8. Inspect bolt hole threads for debris or stripping.
9. Inspect seal grooves for damage.
10. Clean and dry each component.
