L200 L4-2.2L VIN F (2002)
11. Connect transaxle wiring harness to following components:
-
TFP switch assembly
-
Pressure control solenoid (red connector)
IMPORTANT: The 1-2 shift solenoid wires are red and green. The 2-3 shift solenoid wires are red and yellow.
-
1-2 shift solenoid
-
2-3 shift solenoid
-
TCC solenoid
12. Install oil pump shaft into control valve body assembly.
IMPORTANT: If necessary, rotate oil pump shaft while installing oil pump assembly in order to engage shaft splines to splines on oil pump rotor.
13. Install oil pump assembly onto oil pump shaft and control valve body. Hand start and install oil pump assembly bolts
Torque:
Oil Pump Bolts: 12 Nm (9 ft. lbs.)
14. Install transaxle case side cover.
15. Start engine, warm up transaxle, and check for leaks.
16. Check for proper fluid level using the "Transaxle Liquid Level Checking Procedure".
