L200 L4-2.2L VIN F (2002)
5. Using Tie Rod Separator SA91 100C (or equivalent), separate tie rod end from steering knuckle.
6. Remove lower control arm to steering knuckle nut and bolt.
NOTICE: Be careful not to allow steering knuckle to contact ball stud seal. Contact may cause the seal to tear, requiring ball stud replacement.
IMPORTANT: Place a cloth over the ball stud boot protecting it from damage caused by contact with the steering knuckle.
7. Separate lower control arm from steering knuckle.
NOTICE: To prevent damage to CV Joint boots, be careful not to allow them to contact other parts during the removal/installation process. Also,
never pull on the shaft assembly.
8. Using a pry bar, remove drive axle from transaxle.
9. Leave axle in steering knuckle, and tie drive axle out of the way.
