L200 L4-2.2L VIN F (2002)
Torque:
Window Regulator Bolts: 10 N.m (89 in-lbs)
14.
Operate window with switch or window crank and evaluate the operation of door glass.
15.
Install interior and exterior door panels. Refer to Doors/Windows/Mirrors section in the applicable model year Body/Electrical Volume I Service
Manual.
16.
After interior and exterior door panels have been installed re-evaluate the window for smooth operation.
IMPORTANT:
The following steps should only be performed if upon re-evaluation of the window operation, the door glass displays a shudder condition when
disengaging from the window frame header area during downward travel.
1.
If door glass displays a shudder condition when disengaging from the window frame header during downward travel, proceed with the next step.
2.
Remove upper door finish molding (shark fin).
3.
Remove rear run channel upper retaining bolt.
4.
Place a flat bladed screwdriver in between the run channel and the inner door frame to provide a gap between the two.
5.
Using a die grinder carefully elongate the upper mounting hole in the door frame 2 mm in the forward direction.
6.
Touch up any bare metal areas with PPG DP-90 epoxy primer (or equivalent) anti-corrosion primer.
7.
Install rear run channel upper retaining bolt.
8.
Push bolt to forward most position within mounting hole.
Torque:
Rear Run Channel Retaining
Bolt: 10 N.m (89 in-lbs)
9.
Re-evaluate window operation for smooth operation.
10.
Install upper door finish molding (shark fin).
PARTS REQUIREMENTS:
11035625
2 mm Washer
CLAIM INFORMATION:
