L300 V6-3.0L VIN R (2001)
61.8 Install glove compartment door with fasteners.
Torque:
Glove Compartment Door Fasteners: 2 N.m (18 in-lbs)
61.9 Operate glove compartment lamp and glove compartment door to assure proper operation.
62. Install right hinge pillar molding (kick panel).
62.1 Slide hinge pillar molding into carpet retainer.
62.2 Position hinge pillar molding to body and install by pushing gently at clip location.
62.3 Install hinge pillar molding upper push pin fastener.
62.4 Install fuse box door.
62.5 Install weatherstrip over hinge pillar molding cover using a flat blade tool.
63. Install right side carpet retainer (sill plate).
63.1 Position carpet retainer into vehicle.
63.2 Starting at rear of vehicle, slide carpet retainer under rear seat cushion.
63.3 Position carpet retainer over remaining attaching clip locations.
63.4 Gently push on attaching clips to install carpet retainer.
63.5 Install weatherstrip over carpet retainer using a flat blade tool.
CAUTION: MAKE SURE THAT REAR SEAT SHOULDER BELT IS NOT CAUGHT BEHIND BOLSTER WHEN INSTALLING
BOLSTER.
IMPORTANT: If leather rear seat cushion was removed, install it after installing right rear seat bolster.
