L300 V6-3.0L VIN R (2001)
15.
Connect cable conduit to release handle housing.
16. If not already connected, connect release handle wiring harness (included in kit) to release handle.
IMPORTANT:
Due to stiffness of cable conduit, it may be necessary to pre-bend cable conduit prior to handle installation.
17. Align handle to decklid sheet metal as shown.
18. Using the release handle as a template, mark one hole location on decklid sheet metal.
NOTICE:
If drill bit is allowed to drill into sheet metal at a depth greater than 6.5 mm (1/4 in.), outer surface of exterior panel may be penetrated.