saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Interior - Rattling From Headliner Area|Page 12016 > < Headliner - Sags At Rear Of Sunroof|Page 12011
Page 1
background image

Headliner: All Technical Service Bulletins
Interior - Rattling From Headliner Area

BULLETIN NO.: 99-T-69B

ISSUE DATE: August, 2001

CATEGORY TYPE: Body-22

CATEGORY: Interior Trim

CORPORATION NO.: 99-08-59-005B

SUBJECT:
Rattle Noises from Headliner Area 
(Install Soft Foam Spacers on Headliner)

This bulletin has been revised to include 2002 model year vehicles and supersedes bulletin 99-T-69A, which should be discarded.

Refer to Technical Bulletin 00-T-17B for information regarding sagging headliners on sedans equipped with power sunroofs (RPO CF5).

MODELS AFFECTED:
2000 - 2002 Saturn L-Series vehicles

CONDITION:
Some customers may comment about rattle noises heard in area of dome lamp, sunroof, or headliner during normal operating conditions.

CAUSE:
Wiring harness rattling between headliner and roof panel, or headliner alone rattling against roof panel.

CORRECTION:
Install soft foam spacers at headliner locations shown in this bulletin.

PROCEDURE

1.

Test drive vehicle to verify condition and determine area of headliner rattle.

IMPORTANT:

Refer to Technical Bulletin 00-T-17B to repair sagging headliner condition on sedans equipped with power sunroofs (RPO CF5).

2.

Remove headliner from vehicle and place on a clean protected work surface. (Refer to "Headliner" removal procedure in the Interior Trim section
of the appropriate model year L-Series Body/Electrical Volume II Service Manual.)

3.

Obtain 51 cm (20 in.) of KENT Industries adhesive backed foam (P/N 46515). This foam is 25.4 mm (1 in.) wide, so two pieces will have to be
installed side-by-side on headliner to achieve width of spacers necessary.

4.

Cut adhesive backed foam into ten equal 51 mm (2 in.) long pieces.

IMPORTANT:

Since foam spacer locations are different between model years, be sure to follow the location description for the model year being repaired.

5.

Install adhesive backed foam spacers side-by-side on headliner where indicated in illustrations.

^

Sedan without sunroof requires eight soft foam spacers. Sedan with sunroof requires ten soft foam spacers

^

Wagon requires eight soft foam spacers.

6.

Install headliner in vehicle. (Refer to "Headliner" installation procedure in the Interior Trim section of the appropriate model year L-Series
Body/Electrical Volume II Service Manual.)

7.

Test drive vehicle to verify repair.

Interior - Rattling From Headliner Area|Page 12016 > < Headliner - Sags At Rear Of Sunroof|Page 12011