L300 V6-3.0L VIN R (2001)
8. Remove intake runner mounting bolts.
9. Disconnect vent hose from throttle body.
10. Disconnect intake runner from rubber boots and remove intake runner. Note throttle body vent hose routing.
INSTALLATION
1. Install intake runner onto rubber boots.
2. Route throttle body vent hose under vacuum reservoir and connect to throttle body.
3. Install intake runner mounting bolts.
Torque:
Intake Manifold Runner Bolts: 8 Nm (71 inch lbs.)
4. Route intake plenum switch-over valve vacuum hose and connect to switch-over valve.
