saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Exhaust System - Vibration/Boom at Idle With A/C ON|Page 3564 > < Exhaust Manifold Replacement - Front|Page 3555
Page 1
background image

Exhaust Pipe: Customer Interest
Exhaust System - Vibration/Boom at Idle With A/C ON

BULLETIN NO.: O1-T-O1A

ISSUE DATE: February, 2002

CATEGORY TYPE: Engine-01

CATEGORY: Exhaust

CORPORATION NO.: 01-06-05-001A

SUBJECT:
Idle Vibration and/or Boom Noise While A/C is On 
(Install Tuned Mass Damper)

Due to a change in model years affected and location of tuned mass damper, this bulletin has been revised and supersedes bulletin O1-T-01, which
should be discarded.

MODELS AFFECTED:

2001 - 2002 Saturn LS 300 and LW 300 vehicles equipped with V6 (L81) engines

CONDITION:

Some customers may comment about a vibration or boom noise inside the vehicle while at idle and the A/C is ON. The vibration or boom may also be
more noticeable while vehicle is in gear.

CAUSE:
Exhaust system exhibits resonance at idle while A/C is On.

CORRECTION:
Install tuned mass damper onto intermediate exhaust pipe.

SERVICE PROCEDURE

CAUTION:

MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST. TO HELP AVOID PERSONAL INJURY,
PROVIDE ADDITIONAL SUPPORT TO THE OPPOSITE END OF VEHICLE THAT COMPONENTS ARE REMOVED FROM.

1.

Verify the condition by following these steps:

1.1

Start the engine and make sure vehicle is at operating temperature at idle and A/C is On.

IMPORTANT:

The vibration or boom noise is most noticeable with vehicle in gear.

^

If vibration or boom noise is recognized, proceed to step 2.

^

If vibration or boom noise is not recognized, refer to "Exhaust System Diagnostic Chart" in the Exhaust Section of the 2001 or 2002 L-Series
(L81) Engine Service Manual.

2.

Raise vehicle on a hoist.

IMPORTANT:

For proper operation, the tuned mass damper must be installed in the horizontal position (parallel to the floor pan).

Exhaust System - Vibration/Boom at Idle With A/C ON|Page 3564 > < Exhaust Manifold Replacement - Front|Page 3555