L300 V6-3.0L VIN R (2001)
13.
Remove right side heater duct assembly retainer and remove duct.
14.
Locate evaporator access door location on the right side of the module. The entire area inside the raised lip needs to be cut out.
CAUTION:
TO AVOID CUTTING INTERNAL COMPONENTS, CUT ONLY INSIDE THE RAISED BEAD AREA.
NOTICE:
Do not cut through or damage raised bead, this bead will be used as a sealing surface when completing procedure.
15.
Using a sharp utility knife cut through module wall, following inside of raised bead as a guide. Several passes may be necessary to do this.
NOTICE:
Use care when cleaning and removing debris around the evaporator as not to damage the fins.
16.
Carefully clean out any moisture or debris that may be inside the module.
17.
Put on rubber gloves, safety glasses, and NIOSH approved acid gas/organic vapor respirator.
18.
Using cleaning gun, OTC Tool SA9216NE (or equivalent siphon-type parts cleaning spray gun capable of delivering 2 ounces per minute of liquid
with shop air at 552-620 kpa [80-90 psi]), insert siphon hose into container of cooling coil coating. Take care to place the bottle in a secure upright
position to avoid spilling contents.
19.
Regulate shop air to 276-414 kpa (40-60 psi).
20.
Insert nozzle tip of spray gun so spray pattern will be parallel to the evaporator face.
