L300 V6-3.0L VIN R (2001)
32.
Remove protective coverings from interior of vehicle.
33.
Remove pedestal fan from area.
Wire Splicing - General Information For C60 & C68 HVAC Systems
(for both C60 and C68 HVAC Systems)
With the wiring used in the Saturn vehicles, it is recommended that approved Packard Electric Crimp and Seal Splice Sleeves (or equivalent) be used.
The information in this section applies to wire splicing performed in the subsequent sections for both Delayed Blower Kit Installation (manual HVAC,
RPO C60) and Delayed Blower Motor Control Activation (automatic climate control, RPO C68) procedures.
1.
Remove insulation from both ends. Recommended strip length is 9.5 mm (3/8 in.). Caution must be used to prevent cutting the wire strands.
Locate new splice a minimum of 40 mm (1.5 in.) from an outlet or other splice.
2.
Determine proper sleeve for gage of wire.
3.
Position stripped ends in sleeve until wires hit the stop in the center of the splice.
Important:
When using the salmon splice sleeve with .35 mm (22 gage) wire, remove 19 mm (3/4 in.) of insulation. Bend the stripped portion in half to
double the thickness of the wire going into the splice sleeve. Twist the stripped, doubled wire and insert into the splice sleeve.
Important:
When splicing three wire ends into one splice sleeve, insert one cut wire end from vehicle harness and new splice wire end into one side of the
splice sleeve until wires hit stop. Hand crimp using approved crimping tool. Insert remaining cut wire end from vehicle harness into other side
of splice sleeve and crimp.
