L300 V6-3.0L VIN R (2001)
26. Remove glove compartment door.
27. Remove glove compartment bin fasteners.
28. Slowly remove glove compartment bin tilting bin downward to expose the BCM module residing on top of glove compartment.
29. Remove BCM module from glove compartment by sliding module out of attaching slots.
30. Remove glove compartment bin.
31. Locate evaporator access door location on right side of module. The entire area inside raised lip is to be cut out.
CAUTION: TO AVOID CUTTING INTERNAL COMPONENTS, CUT ONLY INSIDE RAISED BEAD AREA.
NOTE: Do not cut through or damage raised bead, this head will be used as a sealing surface when completing procedure.
